操作步骤详解:
————————————————————————————–
方法一:打印底层
Method 1 Print bottom layer
1.操作前请带上棉布手套和橡胶手套
Please wear cotton gloves and rubber gloves
2.需要:无尘布、胶铲、配套U盘、酒精
Need: dust free cloth, plastic shovel, U disk, alcohol
3.插入U盘,配套U盘包含“清除残渣”模型文件
Insert USB flash drive
4.按下开机键,3D打印机开机
3D printer on
5.打开机盖,拧松大螺丝,取下打印平台
Loosen the large screw and remove the printing platform
6.如果打印平台上有树脂,请用废液盘接住
Please use the waste tray to catch it
7.点击“打印”图标,找到“清除残渣-Clear”模型文件
Click the “print” icon to find the “Clear” model file
8.点击右边“打印”按钮,3D打印机开始自动打印
Click the “print” button on the right to start automatic printing
9.打印过程需要3分钟
The printing process takes three minutes
10.打印完成,Z轴将自动上升
After printing, the z-axis will rise automatically
11.点击“确定”,返回主界面
Click “OK” to return to the main interface
12.使用胶铲,沿边缘轻轻分离模型
Using a spatula, gently separate the model along the edge
13.取下模型,请使用废液盘接住
Remove the model, please use the waste liquid tray to catch it
14.模型从离型膜分离,剥离表面残渣
The model was separated from the FEP film and the surface was stripped
————————————————————————————–
方法二:过滤残渣
Method 2 Filter residue
1.拧下料槽固定螺丝,取下料槽
Screw out the fixing screw and take off the chute
2.找到料槽倒料口
Find the chute discharge port
3.使用滤网过滤树脂残渣
Filter resin residue with filter screen
4.使用胶铲,轻轻铲除离型膜表面残渣
Use a rubber shovel to gently remove the residue on the surface of the FEP film
5.使用酒精清洁料槽
Clean the tank with alcohol
6.经过过滤我们得到无杂质的树脂
After filtration, we get the resin without impurities
7.固定螺丝,安装料槽
Fixing screw, installing material trough
8.倒入过滤树脂,过滤料槽残渣完成
Pour in the filter resin and filter the residue in the material tank
总结:
打印底层:操作比较方便一点,适合日常打印清洁料槽树脂。不用拆卸料槽,消耗树脂相对少。注意铲刀刮除模型,不要刮伤离型膜。
过滤残渣:过滤残渣比较彻底,操作相对复杂,合适周期过滤料槽树脂。需要拆卸料槽,来回倒料,器皿上残留比较多树脂。